返回主站 | 设为首页 | 加入收藏      
   
 
  首页 关于我们 产品展示 方案设计 技术分享 行业资讯 联系我们  
 
马达驱动IC/步进电机控制芯片
三相直流无刷BLDC电机驱动IC
单相直流无刷电机驱动芯片
直流无刷电机驱动IC
有刷直流电机驱动IC
步进电机驱动芯片(并行接口)
步进电机驱动芯片(步进/方向接口&串行接口)
静音步进电机驱动芯片
功放IC
电源管理IC
马达驱动IC/步进电机控制芯片
数模(DAC)/模数(ADC)转换芯片
智能处理器
音量控制IC
模拟开关IC
电容式触摸感应IC
RGB LED呼吸趣味灯驱动IC
音频CODEC IC
方案设计
电压电平转换器IC
运算放大器
I/O扩展器IC
 
名称:
种类:
类别:

业务洽谈:

联系人:张顺平 
手机:17727550196(微信同号) 
QQ:3003262363
EMAIL:zsp2018@szczkjgs.com

联系人:鄢先辉 
手机:17727552449 (微信同号)
QQ:2850985542
EMAIL:yanxianhui@szczkjgs.com

负责人联络方式:
手机:13713728695(微信同号) 
QQ:3003207580 
EMAIL:panbo@szczkjgs.com
联系人:潘波

 
当前位置:首页 -> 方案设计
LM5160A宽输入三相逆变器电源参考设计
文章来源: 更新时间:2015/3/31 9:24:00
TI公司的LM5160A系列产品是集成了高边和低边MOSFET的65V 1,5A同步降压转换器,负载电流1.5A,不需要外接回路补偿,快速瞬态响应,可选择CCM或DCM工作,频率可调高达1MHz,具有热关断保护,主要用于工业PLC, IGBT栅极驱动电源,低功率隔离DC/DC转换器(Fly-Buck),汽车电子,通信初级/次级偏压电源,动力线通信等.本文介绍了LM5160A 主要特性,功能框图,几种应用电路,以及三相逆变器电源参考设计主要特性,系统框图,电路图,材料清单和PCB元件布局图.
The LM5160 family is a 65-V, 1.5-A synchronous step-down converter with integrated high-side and low-side MOSFETs. The constant-on-time control scheme requires no loop compensation and supports high step-down ratios with fast transient response. An internal feedback amplifier maintains ±1% output voltage regulation over the entire operating temperature range. The on-time varies inversely with input voltage resulting in nearly constant switching frequency. Peak and valley current limit circuits protect against overload conditions. The under-voltage lockout (EN/UVLO) circuit provides independently adjustable input under-voltage threshold and hysteresis. The LM5160 is programmed through the FPWM pin to operate in continuous conduction mode (CCM) from no load to full load or to automatically switch to discontinuous conduction mode (DCM) at light load for higher efficiency. Forced CCM operation supports multiple output and isolated Fly-Buck applications using a coupled inductor.
The LM5160A shares the same features and pin configuration as the LM5160. An external bias supply can be connected to the VCC pin of the LM5160A in either Buck or Fly-Buck applications. This additional capability can improve efficiency at high input voltages.

LM5160A主要特性:
Wide 4.5-V to 65-V Input Voltage Range
Integrated High and Low Side Switches
No Schottky Diode Required
1.5-A Maximum Load Current
Constant On-Time Control
No External Loop Compensation
Fast Transient Response
Selectable Forced CCM or DCM Operation
CCM Option Supports Multi-Output Fly-Buck
Nearly Constant Switching Frequency
Frequency Adjustable up to 1 MHz
Programmable Soft-Start Time
Pre-Biased Startup
Peak Current Limiting Protection
Adjustable Input UVLO and Hysteresis
±1% Feedback Voltage Reference
LM5160A allows external VCC Bias
Thermal Shutdown Protection
LM5160A应用:
Industrial Programmable Logic Controller
IGBT Gate Drive Bias Supply
Telecom Primary/Secondary Side Bias
E-meter Power Line Communication
Low Power Isolated DC-DC (Fly-Buck)
Automotive Electronics

图1.LM5160A功能框图


图2.LM5160A同步降压应用电路图

图3.LM5160A 12V/4.5W Fly-Buck转换器电路图

图4.LM5160A 12V/4.5W带LM5169A Fly-Buck转换器电路图

三相逆变器电源参考设计
This reference design provides isolated positive and negative voltage rails required for Insulated Gate Bipolar Transistor (IGBT) gate drivers from a single 24-volt DC input supply. Utilizing a Fly-Buck™ control topology, this reference design uses a single transformer for generating power rails for all three arms of the 3-phase inverter.  It uses primary-side regulation and can achieve good cross regulation without opto-coupler feedback or an auxiliary winding. The isolated outputs are generated through the coupled windings of the transformer. The voltage rails for all the high-side IGBTs are individually isolated, whereas the voltage rails for all low-side IGBTs are combined.

三相逆变器电源参考设计主要特性:
• Isolated power supply with 24V±20% input range that supports 6 IGBT gate drivers for 3-phase inverter (each arm in half-bridge configuration)
• Low-ripple (<200mV) bias outputs (+15V & -8V) with output power of 2.3W for each IGBT of the 3-phase inverter
• Fly-Buck topology provides easy-to-design multi-output isolated power supply solution with primary side regulation
• Peak efficiency of 82% at balanced full-load
• Output capacitors rated to support up to 6A peak gate drive current

三相逆变器电源参考设计主要应用:
• Variable Speed AC and DC Drives
• Industrial Inverters and Solar Inverters
• UPS Systems
• Servo Drives
• IGBT Based High-Voltage DC (HVDC) Systems
Wide-Input Isolated IGBT Gate-Drive Fly-Buck Power Supply for Three-Phase Inverters
图5.三相逆变器电源参考设计外形图
Wide-Input Isolated IGBT Gate-Drive Fly-Buck Power Supply for Three-Phase Inverters

图6.带隔离栅极驱动的三相逆变器电源参考设计框图

图7.三相逆变器电源系统框图


图8.三相逆变器电源TIDA-00199电路图
三相逆变器电源TIDA-00199材料清单:



图9.三相逆变器电源TIDA-00199 PCB元件布局图


 
 
 
    相关产品  
 
深圳市永阜康科技有限公司 粤ICP备17113496号  服务热线:0755-82863877 手机:13242913995